Engines and Clutches cause an explosion, resulting in serious personal injury or death. A unit or installation which is as independent as possible from external influences. 4. If so equipped, turn off the battery disconnect switch after the engine is stopped to prevent bat- tery discharge while the starter motor is cooling. Modifications which maintain satisfactory oper- ating temperatures with a minimum increase in maintenance of the equipment and accesso- ries. For starting below 0°F (–18°C), an optional cold- weather starting assist is recommended. For temperatures below (–23°C), consult your Caterpillar dealer for recommendations.
If satisfactory engine temperature is not maintained, higher maintenance cost will result due to increased engine wear. Special provisions to overcome low temperatures are definitely necessary, whereas a change to a warmer climate normally requires only a minimum of revision. Most of the accessories should be designed in such a way that they can be discon- nected so there is little effect on the engine when they are not in use. 5.
When the customer parameters include cold mode operation and the coolant temperature is below 64°F (18°C), the system puts the engine in cold mode, limiting engine power, advancing tim- ing, and adjusting the low idle to 600 rpm (for C-15 engines) or 800 rpm (for C-10 and C-12 engines) to improve warm-up time. The system will keep the engine in cold mode until the cool- ant temperature rises above 82°F (28°C). After the cold mode has been completed, operate the vehicle at low load and low rpm until the engine coolant reaches the normal operating tempera- ture of 189°F (87°C).
The two most commonly used terms associated with preparation of equipment for low-temperature opera- tion are "winterization" and "arctic specifications." Winterization of the engine and/or components so that starting and operating are possible in the lowest temperature to be encountered, requires: 6. Fuel cloud point is the temperature at which wax crystals become visible, which is generally above the pour point of the fuel. To keep the fuel filter elements from plugging with wax crystals, the cloud point should be no higher than the lowest ambient temperature at which the engine must start. A. Proper lubrication with low-temperature lubricat- ing oils. B.
Protection from the low-temperature air. The metal temperature does not change, but the rate of heat dissipation is affected. C. Fuel of the proper grade for the lowest tempera- ture. Cummins Satisfactory performance of a diesel engine operating in low ambient temperatures requires modification of the engine, surrounding equipment, operating prac- tices, and maintenance procedures. The colder the temperatures, the greater the amount of modification required, and yet with the modifications applied the engines must still be capable of operation in warmer climates without extensive changes. D.
Heat to raise the engine block and component temperatures to at least (–32°C) for start- ing in lower temperatures. E. Electrical equipment capable of operating in the lowest expected temperature. All switches, con- nections, and batteries in the electrical system should be inspected and kept in good condition to prevent losses through poor contacts. Arctic specifications refer to the design of material and specifications of components necessary for sat- isfactory engine operation in extremely low tempera- tures to (–54°C). Contact the nearest Freight- liner dealer or Cummins engine dealer, to obtain the special items required.
The following information is provided to engine own- ers, operators, and maintenance personnel on how the modifications can be applied to get satisfactory performance from their diesel engines. There are three basic objectives: Reasonable starting characteristics followed by practical and dependable warm-up of the en- gine and equipment. 7.6