Engines and Clutches CAUTION as long as the recommended concentration range of 30 to 67 percent (antifreeze to water by volume) is employed. See Group 20 of the Heavy-Duty Trucks Maintenance Manual for cool- ing system capacity and quantity of antifreeze required for the lowest anticipated temperature. "Antileak" antifreezes are not recommended for use in Cummins engines. Although these anti- freezes are chemically compatible with DCA water treatment, the "antileak" agents may clog the coolant filters. IMPORTANT:
Fuel heaters used on vehicles with Cummins PACE or CELECT engine sys- tems could cause high fuel temperatures that affect engine performance and operation of the electronic engine controls. If a fuel heater is used, make sure it has thermostatic controls. If the fuel heater has a timer, set the timer to acti- vate only for a limited period of time before the engine starts. Make sure the fuel heater is used only for starting the engine. 6. If the engine is to be operated in arctic tempera- tures, consult the nearest Freightliner dealer or an authorized Detroit Diesel engine dealer for information regarding availability of special cold weather equipment.
Engine Break-In Every engine is tested on a dynamometer before shipment, eliminating the need for a break-in period. Before running the engine for the first time, follow the instructions in the Engine Operator’s Manual. Detroit Diesel Engine Operation Preparations made in advance of winter and mainte- nance performed during the cold months will help to ensure efficient engine starting and operation. DANGER Do not operate the engine in an area where flam- mable vapors such as gasoline or diesel fumes are present. Shut down the engine when in an area where flammable liquids or gases are being handled. Failure to observe these precautions could result in serious injury or death. 1.
Engine oil thickens as it gets colder, slowing cranking speed. When cold, multigrade oil offers less resistance to the cranking effort of the en- gine and permits sufficient rpm to be developed to start the engine. Refer to "Lubricating Oil Rec- ommendations" in the Detroit Diesel Owner’s and Operator’s Guide for specific recommendations. All diesel engines have been built to comply with the requirements of the Federal (U.S.) Clean Air Act. Once an engine is placed in service, the responsibil- ity for meeting both state and local regulations is with the owner/operator.
Good operating practices, regular maintenance, and correct adjustments are factors that will help to stay within the regulations. Proper maintenance of the engine, which is the responsibility of the owner/operator, is essential to keep the emis- sion levels low. 2. When an engine equipped with a DDEC system is started at temperatures below 25°F (–4°C), the idle speed automatically increases to 900 rpm. The injection timing is also advanced to de- crease white smoke. As the engine oil warms up, the idle speed gradually decreases. When the oil temperature reaches 122°F (50°C), both the idle speed and the injection timing return to normal. 3.
During cold weather, the batteries should be tested more frequently to ensure ample power for starting. All electrical connections should be tight and in good condition to prevent losses through loose or corroded connections. Engine Protection On electronic engines, an engine-protection system monitors all engine sensors and electronic compo- nents, and recognizes system malfunctions. If a criti- cal fault is detected, an amber check-engine warning lamp and a red stop-engine lamp illuminate. 4. The ether start system should be properly charged and in good working order. 5. Ethylene-glycol-base antifreeze is recommended.
An inhibitor system is included in this type of an- tifreeze and the corrosion protection is sufficient The standard parameters that are monitored for en- gine protection are: low coolant level, high coolant 7.7