Freightliner FLD Conventional — FLD Conventional

Engines and Clutches temperature, low oil pressure, high soot level (DPF), and uncontrolled DPF regeneration. hicle to a safe stop and restart the engine with the vehicle stopped. Amber Check-Engine Warning Lamp When the amber check-engine warning lamp comes on for any reason, the vehicle can still be operated, and the driver can proceed to the required destina- tion. This condition should be reported to an autho- rized service center as soon as possible. Stop-Engine Override Switch If the vehicle is equipped with a stop-engine override (SEO) switch, it can be used to override the shut- down sequence.

This override resets the shutdown timer, restoring power to the previous level before the red stop-engine lamp was illuminated. The switch must be recycled after five seconds to obtain a sub- sequent override. Red Stop-Engine Lamp WARNING CAUTION When the red stop-engine light illuminates, most engines are programmed to shut down automati- cally within 30 seconds. The driver must immedi- ately move the vehicle to a safe location at the side of the road to prevent causing a hazardous situation that could cause bodily injury, property damage, or severe damage to the engine. Using the override button so the engine operates for an extended period may result in engine dam- age.

The operator has the responsibility to take action to avoid engine damage. Caterpillar Engine Operation The red stop-engine lamp illuminates to indicate that the engine-protection system has been activated. The conditions that will cause the red stop-engine lamp to come on are: Proper operation and maintenance are key factors in obtaining the maximum life and economy of a vehicle engine. Follow the directions in the Caterpillar Opera- tion and Maintenance Management Manual and this manual for trouble-free, economical engine operation. high coolant temperature 1. Operate the engine at low load.

After normal oil pressure is reached and the temperature gauge begins to move, the engine may be operated at full load. loss of coolant low oil pressure high soot level (DPF) Caterpillar electronic engines automatically idle at 900 to 1000 rpm for the correct warm up time after a cold engine start (less than 40°F [5°C]). These electronic engine systems will reduce the idle speed to 600 rpm when the engine is warm enough to drive the vehicle. uncontrolled DPF regeneration On some engines, the engine ECU will derate the engine, allowing it to run at low rpm and slow vehicle speed, until the vehicle can be driven to a safe loca- tion or to a service facility.

On other engines, the en- gine ECU will first derate the engine, then if the con- dition does not improve, shut it down completely 30 seconds after the light comes on. The driver must safely bring the vehicle to a stop on the side of the road before the engine shuts down. IMPORTANT: Fuel heaters used on vehicles with Caterpillar electronic engines could cause excessive fuel temperatures that affect engine performance and operation of the electronic en- gine controls. If a fuel heater is used, make sure it has thermostatic controls. If the fuel heater has a timer, set the timer to activate only for a limited period of time before the engine starts.

Make sure the fuel heater is used only for start- ing the engine. To restart the engine (override the shutdown com- mand) turn the ignition switch to OFF, leave it there a few seconds, and turn the switch to START. The en- gine will run for a short period and shut down again if the condition does not improve. IMPORTANT: Do not attempt to restart the en- gine while the vehicle is moving. Bring the ve- 2. Keep the engine speed to a minimum. An ac- ceptable range is 1200 to 1600 rpm. 7.8