Engines and Clutches 3. Select a gear that allows a smooth, easy start without increasing engine speed above low idle or slipping the clutch. Engage the clutch smoothly. Jerky starts waste fuel and put stress on the drivetrain. 7. As with any engine, prolonged idling of Caterpil- lar engines is not recommended. An idling en- gine wastes fuel and if left unattended, is also unsafe. Caterpillar engines can be programmed to shut off automatically after a specified idling time. The vehicle transmission must be in neutral and the parking brake must be set for the automatic shut- off option to work.
It is not necessary to accelerate Caterpillar elec- tronic engines to governed speed in the lower gears to get the vehicle moving, except in a high power demand situation such as starting on a grade. 4. Continue to upshift until cruising speed is reached. Use only the rpm needed to make an upshift into the next gear. The engine speed needed to make an upshift increases as the ve- hicle speed increases or if upshifts are made on uphill grades. If the vehicle can be operated in a higher gear after reaching the desired speed, select the highest gear available that will pull the load. Experience with your vehicle will show you what rpm is needed to make upshifts under vari- ous conditions.
This progressive shifting tech- nique will lower fuel costs because the engine will be operating at the lowest rpm needed to pull the load. Cruise Control The cruise control is activated by the "On/Off" and "Set/Resume" switches on the dash ( Fig. 7.5 ) or by optional "Pause," "Resume," and "Set" buttons on the transmission shift knob ( Fig. 7.6 ). The minimum speed at which cruise control can be used on Cater- pillar electronic engines is 30 mph (48 km/h). The minimum and maximum speed cruise control set lim- its can be programmed, by authorized personnel, into the ECM personality module.
Caterpillar electronic engines can be pro- grammed to limit engine rpm while the vehicle is operated in the lower and higher gears. This fea- ture assists the driver in following progressive shifting techniques. 5. On uphill grades, begin downshifting when the engine rpm falls to 1200 rpm. Fuel economy will be best if you let the engine lug back to around this speed before you downshift. Downshift until a gear is reached in which the engine will pull the load. Let the engine lug down if you can make it to the top of a hill without downshifting. A 03/30/94 f600705 IMPORTANT: Don’t let the engine exceed 2300 rpm (2100 rpm if equipped with an exhaust brake). A.
If equipped with Jacobs engine brake controls, the cruise switches may be installed here. The location may vary depending on other vehicle options. 6. On a downhill grade, do not coast or put the transmission in neutral. Select the correct gear that does not allow the engine to exceed its maximum speed. Use the brakes to limit the ve- hicle speed. Fig. 7.5, Cruise Control Switches, Standard Location WARNING Do not use the cruise control system when driv- ing conditions do not permit maintaining a con- stant speed, such as in heavy traffic or on roads that are winding, icy, snow covered, slippery, or roads with a loose driving surface.
Failure to fol- low this precaution could cause a collision or A simple rule to follow is to select the same gear (or one gear lower) that would be needed to go up the grade. 7.9