Freightliner FLD Conventional — FLD Conventional

Engines and Clutches the cooling system is for the control of the tem- perature of the oil at full engine power or full BrakeSaver capacity, but not both at the same time. Cummins Engine Operation Cummins diesel engines have been built by Cum- mins to comply with the requirements of the Federal (U.S.) Clean Air Act. Once the engine is placed in service, the responsibility for meeting both state and local regulations is with the owner/operator. Good operating practices, regular maintenance, and proper adjustments are factors which will help to stay within the regulations. Power Takeoff (PTO) Governor Caterpillar electronic engines may be equipped with a PTO governor.

This mode is used only when the vehicle is parked. The PTO mode is activated by the ON/OFF and SET/RESUME switches on the dash ( Fig. 7.5 ) or by optional PAUSE, RESUME, and SET buttons on the transmission shift knob ( Fig. 7.6 ). Proper maintenance of the engine, which is the re- sponsibility of the owner/operator, is essential to keep the emission levels low. 1. To engage the PTO: 1.1 Flip the ON/OFF switch on the instrument control panel to ON. Follow the directions in the Cummins Operation and Maintenance Manual and this manual for trouble- free, economical vehicle engine operation. 1.2 Hold the throttle pedal until the tachometer indicates the desired speed. 1.

Cummins diesel engines produce high horse- power and peak torque characteristics at lower rpm. Because of this, it is not necessary to keep the engine "wound up" to deliver the required horsepower at the wheels. These characteristics may also result in less shifting, and make shifting at lower rpm (to peak torque) more practical. 1.3 Momentarily move the SET/RESUME switch on the instrument control panel to SET, or push the SET button on the trans- mission shift knob. 2. To disengage the PTO: 2.1 Depress the brake pedal, or clutch pedal, or 2.

Depending on the vehicle gearing, the posted speed limit can sometimes allow operation in ei- ther of the top two gears; however, for improved operating efficiency (fuel economy and engine life), operate in the top gear at reduced rpm, rather than in the next lower gear at the maxi- mum rpm. 2.2 Flip the ON/OFF switch on the instrument control panel to OFF or press the PAUSE button on the shift knob. 3. To resume a previously selected engine speed: 3.1 If the ON/OFF switch on the instrument control panel is in the OFF position, flip it to ON. 3. Cruise at partial throttle whenever road condi- tions and speed requirements permit.

This driv- ing technique permits operating within the most economical power range of the engine. 3.2 Momentarily move the SET/RESUME switch on the instrument control panel to RESUME, or press the RESUME button on the transmission shift knob. 4. When approaching a hill, open the throttle smoothly to start the upgrade at full power, then shift down as desired to maintain the maximum vehicle speed. The higher torque of Cummins engines may permit topping some grades without shifting.

To adjust engine speed up or down, hold the SET/RESUME switch on the instru- ment control panel at SET to accelerate or at RESUME to decelerate until the desired speed is reached, or press the SET button on the transmission shift knob to acceler- ate or the RESUME button to decelerate until the desired speed is reached. 5. Cummins engines are designed to operate over a wide speed range. More frequent shifting than necessary does not allow proper utilization of this flexibility. The driver who stays in top gear and uses the wider speed range will achieve the best fuel economy. NOTE: The resume-engine-speed memory is not maintained if the ignition is shut off. 6.

The Cummins diesel engine is effective as a brake on downhill grades, but care must be used 7.11