Freightliner FLD Conventional — FLD Conventional

Engines and Clutches not to overspeed the engine going downhill. The governor has no control over engine speed when it is being pushed by the loaded vehicle. 1.2 Hold the throttle pedal until the speedom- eter indicates the desired speed. 1.3 Momentarily move the SET/RESUME switch on the instrument control panel to SET or push the SET button on the trans- mission shift knob. Never turn off the ignition switch while going downhill. With the engine still in gear, fuel pres- sure will build up against the shutdown valve and may prevent it from opening when the ignition key is turned on. 2. To disengage the cruise control:

CAUTION 2.1 Depress the brake pedal, or clutch pedal, or Engine overspeed (engine speed exceeds high idle, no-load rpm) can damage the engine. 2.2 Flip the ON/OFF switch on the instrument control panel to OFF or push the PAUSE button on the transmission shift knob. 7. Use a combination of brakes and gears to keep the vehicle under control at all times and to keep the engine speed below the rated governed rpm. 3. To resume a preselected cruise speed: 3.1 If the ON/OFF switch on the instrument control panel is in the OFF position, flip it to ON. Cruise Control The cruise control is activated by the ON/OFF and SET/RESUME switches on the dash ( Fig.

7.5 ) or by optional PAUSE, RESUME, and SET buttons on the transmission shift knob ( Fig. 7.6 ). The minimum speed at which cruise control can be used on Cum- mins PACE and CELECT engines is 30 mph (48 km/h). 3.2 Momentarily move the SET/RESUME switch on the instrument control panel to RESUME, or push the RESUME button on the transmission shift knob. Cruise will return to the last speed selected.

To adjust cruise speed up or down, hold the SET/RESUME switch on the instru- ment control panel at SET to accelerate or at RESUME to decelerate until the desired speed is reached, or press the SET button on the transmission shift knob to acceler- ate or the RESUME button to decelerate until the desired speed is reached. WARNING Do not use the cruise control system when driv- ing conditions do not permit maintaining a con- stant speed, such as in heavy traffic or on roads that are winding, icy, snow covered, slippery, or roads with a loose driving surface.

Failure to fol- low this precaution could cause a collision or loss of vehicle control, possibly resulting in per- sonal injury or property damage. NOTE: The resume-vehicle-speed memory is not maintained if the ignition is shut off. Power Takeoff (PTO) Governor CAUTION Cummins electronic engines may be equipped with a PTO governor. This mode is used only when the ve- hicle is parked. The PTO mode is activated by the ON/OFF and SET/RESUME switches on the dash ( Fig. 7.5 ) or by optional PAUSE, RESUME, and SET buttons on the transmission shift knob ( Fig. 7.6 ). Do not attempt to shift gears without using the clutch pedal when the cruise control is engaged.

Failure to follow this precaution will result in a temporarily uncontrolled increase in engine speed; transmission damage and gear stripping could result. 1. To engage the PTO: 1. To cruise at a particular speed: 1.1 Flip the ON/OFF switch on the instrument control panel to ON. 1.1 Flip the ON/OFF switch on the instrument control panel to ON. 1.2 Hold the throttle pedal until the tachometer indicates the desired speed. 7.12