Engines and Clutches 1.3 Momentarily move the SET/RESUME switch on the instrument control panel to SET, or push the SET button on the trans- mission shift knob. All engines have an operating range in which the en- gine performs most efficiently. The operating range extends from maximum torque rpm at the low end to engine rated speed at the high end. Detroit Diesel engines deliver best fuel economy when operated in the low- and mid-speed segments of the efficiency range and produce maximum horsepower at rated speed, which is also the recommended maximum speed of the engine. IMPORTANT: Two PTO engine speeds can be preset on PACE and CELECT engines.
With the ON/OFF switch on, move the SET/ RESUME switch to SET to reach the first preset value or, move the switch to RE- SUME for the second preset value. After one preset value has been selected, you must turn the ON/OFF switch off, then turn it back on before using the second preset value. IMPORTANT: If a winterfront is used on a ve- hicle with an electronic engine equipped with a charge air cooler, make sure that there are slit openings distributed across the face of the win- terfront to allow airflow through the entire charge-air-cooler core. Do not use a winterfront with closed areas that block uniform air flow across any sections of the charge-air-cooler crossflow tubes.
This will adversely affect the operation and durability of the charge air cooler. 2. To disengage the PTO: 2.1 Depress the brake pedal, clutch pedal, or throttle pedal (CELECT engines only), or 2.2 Flip the ON/OFF switch on the instrument control panel to OFF or press the PAUSE button on the shift knob. 1. It is seldom necessary to accelerate the engine to governed speed in the lower gears to get the vehicle moving, except in a high power demand situation such as starting on a grade. 3. To resume a previously selected engine speed: 3.1 If the ON/OFF switch on the instrument control panel is in the OFF position, flip it to ON.
To conserve fuel, start off in low gear and de- velop only the engine speed needed to get roll- ing. Then, increase engine speed gradually as upward gear shifting progresses. 3.2 Momentarily move the SET/RESUME switch on the instrument control panel to RESUME, or press the RESUME button on the transmission shift knob. As described by Detroit Diesel, this "progressive shifting" technique will get the vehicle up to the desired cruising speed while minimizing noise emission and maximizing fuel economy. A pro- gressive shift pattern is illustrated in Fig. 7.7 .
3.3 To adjust engine speed up or down, hold the SET/RESUME switch on the instru- ment control panel at SET to accelerate or at RESUME to decelerate until the desired speed is reached, or press the SET button on the transmission shift knob to acceler- ate or the RESUME button to decelerate until the desired speed is reached. 2 NOTE: The resume-engine-speed memory is not maintained if the cruise control ON/OFF switch is turned OFF or if the ignition is shut off. 0 10 (16) 20 (32) 30 (48) 40 (64) 50 (80) 60 (97) Detroit Diesel Engine Operation 4 1. Governed RPM 2. Engine RPM 3. Idle RPM 4.
Miles (Kilometers) Per Hour f250319 11/02/95 Individual driving habits can make a difference in the performance and economy of any engine. The rec- ommendations below call attention to the techniques that can be employed to save fuel and extend the operating efficiency and life of a new Detroit Diesel engine for the longest possible time. Fig. 7.7, Progressive Shift Pattern 7.13