Freightliner FLD Conventional — FLD Conventional

Engines and Clutches NOTE: A momentary hesitation in throttle re- sponse will occur when a vehicle with a turbo- charged engine is started on a grade. Do not disengage the clutch. The rpm will recover, and the vehicle will accelerate up the grade. engine life. And more than likely, it will be pos- sible to top most grades without downshifting. When the vehicle starts into a grade, allow the engine to lug down to maximum torque rpm be- fore downshifting. Downshift, if required, at maxi- mum torque rpm also or at the predetermined road speed for the next lower gear. 2. For city driving, run in the highest gear possible and reduce engine speed.

This enables you to operate at a safe speed for traffic conditions while using less fuel and reducing noise. Also, when slowing down for reduced speed zones, remain in your running gear and reduce engine rpm to stay within the speed limit. Avoid down- shifting until you are ready to return to highway cruising speed. Do not be afraid to lug the engine down. It has more than enough torque at low rpm to keep a loaded vehicle moving against a grade and it won’t harm the engine. 6. The driver who is not familiar with the vehicle’s shift points can greatly improve driving skill by learning them for all gears.

By knowing rather than guessing where the shift points are, it is possible to avoid overspeeding the engine by downshifting too soon or missing the full use of a gear by downshifting too late. The shift points of any vehicle can be determined by a simple road- test method. Run the vehicle and determine the maximum road speed possible in every gear at the engine governed full-load speed setting. 3. For highway cruising and for best fuel economy, run the engine at 80 to 90 percent of rated rpm to maintain highway speed. Engines with 1800 rpm ratings are exceptions and will provide fuel economy when run at their rated speed.

Proper gear selection should permit cruising in the economy range with no appreciable sacrifice in desired highway speed. It is okay to operate below rated rpm at full throttle if you are satisfied with the way the ve- hicle performs. However, there are times when hilly terrain, high winds, or other conditions make it impractical to operate without reserve power. Such conditions are better met if the vehicle is operated in a lower gear with reserve power available for changes in terrain, wind, etc. The top road speed possible in a gear would be the shift point for that gear. The results should be recorded in the proper order of shifting and dis- played inside the cab.

CAUTION Do not allow the engine to exceed its governed speed, or serious engine damage could result. 4. The proper use of gears will shorten time on hills and minimize the amount of shifting. When start- ing up a hill, gradually depress the accelerator pedal all the way down and keep it there as the vehicle moves up the grade. If the engine contin- ues to maintain a satisfactory road speed, re- main in that gear for the entire grade. 7. To slow the vehicle on downgrades and curves (using the engine), shift to a lower gear and allow the vehicle to decelerate in that gear.

The engine provides maximum braking effect when running at the top end of the operating range, but it must not be allowed to exceed its full-load rated rpm. Continue to downshift as further re- duction in vehicle speed is required. If the ve- hicle is above the allowable maximum speed of a lower gear, use the service brakes to slow the vehicle to an acceptable speed where the trans- mission may be downshifted safely. Again, the importance of knowing the shift points is demon- strated. If the hill causes a steady decline in engine rpm, downshift as required until the engine can main- tain a stable uphill speed. Make full use of each gear before going to a lower gear.

By remaining in a gear until arriving at the speed of the next lower gear, the vehicle will top the grade in the best possible time on less fuel and fewer shifts. 5. Because of their constant horsepower over a wide speed range, Detroit Diesel engines can be operated at full throttle at lower rpm than other engines. This offers benefits in fuel economy and IMPORTANT: The engine governor has no con- trol over engine rpm when the engine is being pushed by a loaded vehicle down a grade. Use service brakes and gears in combination on 7.14