Freightliner FLD Conventional — FLD Conventional

Engines and Clutches long grades to keep the vehicle speed under control and the engine rpm below full-load rated governed speed. low this precaution could cause a collision or loss of vehicle control, possibly resulting in per- sonal injury or property damage. 8. Essential information regarding the operation and care of Allison automatic transmissions is con- tained in the Allison Driver’s Handbook. Applying the knowledge presented will not only make driv- ing easier, but will give the maximum benefits from an Allison-equipped vehicle. CAUTION Do not attempt to shift gears without using the clutch pedal when the cruise control is engaged.

Failure to follow this precaution will result in a temporarily uncontrolled increase in engine speed; transmission damage and gear stripping could result. Maintenance literature is also available for driv- ers of Allison-equipped vehicles who desire trouble-free performance and maximum life from their equipment. These maintenance books are available from any authorized Detroit Diesel en- gine distributor. 1. To cruise at a particular speed: 1.1 Flip the ON/OFF switch on the instrument control panel to ON. 9. As with all engines, prolonged idling of Detroit Diesel engines is not recommended. An idling engine wastes fuel and left unattended, is also unsafe.

1.2 Hold the throttle pedal until the speedom- eter indicates the desired speed. 1.3 Momentarily move the SET/RESUME switch on the instrument control panel to SET or push the SET button on the trans- mission shift knob. A Detroit Diesel Electronic Control (DDEC) en- gine can be equipped to shut off automatically after 5 minutes of idling. The vehicle transmis- sion must be in neutral and the parking brake must be set for the automatic shutoff option to work. To start the engine, follow the normal start-up procedure. 2. To deactivate the cruise control:

2.1 Depress the brake pedal, or clutch pedal, or 2.2 Flip the ON/OFF switch on the instrument control panel to OFF or push the PAUSE button on the transmission shift knob. Engines equipped with DDEC will idle fast when cold. As the engine warms up to operating tem- perature, the idle speed will decrease. Warm the engine until idle speed is normal before operat- ing the vehicle. 3. To resume a preselected cruise speed: 3.1 If the ON/OFF switch on the instrument control panel is in the OFF position, flip it to ON. Cruise Control A DDEC engine may have cruise control. The mini- mum speed at which cruise control can be used is 35 mph (56 km/h).

3.2 Momentarily move the SET/RESUME switch on the instrument control panel to RESUME, or push the RESUME button on the transmission shift knob. Cruise will return to the last speed selected. The cruise control is activated by the ON/OFF and SET/RESUME switches on the dash ( Fig. 7.5 ) or by optional PAUSE, RESUME, and SET buttons on the transmission shift knob ( Fig. 7.6 ). To adjust cruise speed up or down, hold the SET/RESUME switch on the instru- ment control panel at SET to accelerate or at RESUME to decelerate until the desired speed is reached, or press the SET button on the transmission shift knob to acceler- ate or the RESUME button to decelerate until the desired speed is reached.

WARNING Do not use the cruise control system when driv- ing conditions do not permit maintaining a con- stant speed, such as in heavy traffic or on roads that are winding, icy, snow covered, slippery, or roads with a loose driving surface. Failure to fol- 7.15