Freightliner FLD Conventional — FLD Conventional

Engines and Clutches NOTE: The resume vehicle speed memory is not maintained if the ignition is shut off or if the ON/OFF switch is off for more than 10 seconds. 3. To resume a previously selected engine speed: 3.1 If the ON/OFF switch on the instrument control panel is in the OFF position, flip it to ON. Power Takeoff (PTO) 3.2 Momentarily move the SET/RESUME switch on the instrument control panel to RESUME or press the RESUME button on the transmission shift knob. A power takeoff option is available for vehicles equipped with a DDEC system. The PTO operates only when the vehicle is at a standstill.

To adjust engine speed up or down, hold the SET/RESUME switch on the instru- ment control panel at SET to accelerate or at RESUME to decelerate until the desired speed is reached, or press the SET button on the transmission shift knob to acceler- ate or the RESUME button to decelerate until the desired speed is reached. Some vehicles have separate controls for the PTO. In the case of a preset nonadjustable PTO engine speed, there is only an on/off switch labeled FAST IDLE. If the vehicle is equipped with a variable PTO engine speed, there are two controls: an on/off switch, and a potentiometer knob. Both of these are labeled GOVERNOR.

On other vehicles, the PTO mode is activated by the ON/OFF and SET/RESUME cruise control switches located on the instrument control panel on the dash ( Fig. 7.5 ), or by optional PAUSE, RESUME or SET buttons on the transmission shift knob ( Fig. 7.6 ). Optimized Idle ® The Optimized Idle option on DDEC III-equipped ve- hicles is a system that automatically stops and re- starts the engine to accomplish the following: 1. Operating the PTO With Separate PTO Controls: Keep the engine oil temperature between 60 to 104°F (16 to 40°C) 1.1 Set the parking brake. Keep the battery charged 1.2 Turn on the switch labeled GOVERNOR (or FAST IDLE for vehicles with a preset PTO system).

Keep the cab or sleeper at a constant, desired temperature (if equipped with a thermostat) 1.3 For vehicles with a variable PTO, use the potentiometer knob to adjust the engine rpm. The benefits of the system include reduced engine idle time, fuel savings, reduction of exhaust emis- sions and noise, increased starter and engine life, and less chance of dead batteries due to electrical loads. 2. Operating the PTO Using Cruise Control Switches: 2.1 To engage the PTO, flip the ON/OFF switch on the instrument control panel to ON. Optimized Idle operates in two modes. They are the engine mode or the thermostat mode.

The engine mode keeps the battery charged and the engine oil temperature within factory set limits. The thermostat mode is the same as the engine mode, but also keeps the cab and sleeper at a constant preset tem- perature. 2.2 Hold the throttle pedal until the tachometer indicates the desired speed. 2.3 Momentarily move the SET/RESUME switch on the instrument control panel to SET or push the SET button on the trans- mission shift knob. The engine mode is always activated when the sys- tem is operated. The thermostat mode is activated when the thermostat is turned on.

2.4 To disengage the PTO, depress the brake pedal, or clutch pedal, or flip the ON/OFF switch on the instrument control panel to OFF or press the PAUSE button on the shift knob. The thermostat mode controls the set point, which is the desired temperature of the cab and sleeper, and the comfort zone, which is the number of degrees from the set point before the engine needs to heat or 7.16