Engines and Clutches cool the cab. There are three comfort zones: 4°F (2°C), 7°F (4°C), or 10°F (6°C). The display normally shows the temperature of the sleeper, but changes accordingly as the buttons are pressed. Vehicles equipped with Optimized Idle have a label and light on the dashboard. The dash light is the bot- tom one on the vertical array of lights in the center dash panel, and the label is located on the "B" dash panel. See Fig. 7.8 for the label appearance. If equipped with the thermostat mode, a thermostat is located in the sleeper, above the bunk. See Fig. 7.9 . The button functions are as follows: Up Button: increases the set point and comfort zone. Down Button:
decreases the set point and comfort zone. Cool/Heat Button: detects either cooling or heating operation. Mode Button: scrolls through the various func- tions. It can also be used to set desired tem- perature values. 1. Activate Optimized Idle (engine mode) as fol- lows: 1.1 Set the parking brake. 1.2 If it is tilted, close and secure the hood. 11/13/96 f080062 1.3 Start the engine and let it idle. Fig. 7.8, Optimized Idle Dash Label 1.4 Put the transmission in neutral and in the high range, if so equipped. 3 4 5 1.5 Turn on the cruise control. IMPORTANT: The cruise control must be turned on after the engine is idling.
If it was previously turned on, turn off the cruise con- trol, then turn it on again. 2 MODE 6 °F 7 °C 8 1.6 The dash light will begin blinking, indicat- ing that Optimized Idle is active. The sys- tem is now in the engine mode, and after an initial phase in which the idle speeds up to 1000 or 1500 rpm (depending on the outside temperature), the engine will stop and start automatically to keep the battery charged and the engine oil warm. The dash light stays on and shines steadily at this point. 1 9 10 f601250 1. Down Button 2. Up Button 3. Upper/Lower Temperature Icon 4. Temperature Display 5. Degrees Fahrenheit Indicator 6. Mode Button 7. Cooling Icon 8. Cool/Heat Selection Button 9.
Heating Icon 10. Degrees Celsius Indicator 11/08/96 2. Activate the thermostat mode (if so equipped) as follows: NOTE: When the system is in the thermostat mode, it is also in the engine mode. It will continue to operate in the engine mode even if the thermostat mode is turned off. Fig. 7.9, Optimized Idle Thermostat The thermostat consists of an LCD readout and four buttons. 7.17 OPTIMIZED IDLETM TO USE:
− IDLE ENGINE − CLOSE HOOD − ENGAGE PARKING BRAKES − PUT TRANSMISSION IN NEUTRAL AND HI RANGE (IF EQUIPPED) − THEN, MOVE CRUISE SWITCH FROM OFF TO ON − IF DESIRED, TURN CAB THERMOSTAT ON (IF EQUIPPED) TO AVOID UNINTENTIONAL VEHICLE MOVEMENT, DO NOT MOVE SHIFT LEVER OR RANGE SELECTOR WHEN OPTIMIZED IDLE IS ON