Engines and Clutches 2.1 With the system in the engine mode, set the cab and sleeper heater or air condi- tioner controls to the highest setting. The drive away feature allows the use of all the DDEC features. Use the drive away feature as follows: 2.2 Turn on the thermostat by touching any of the four buttons. See Fig. 7.9 . 5.1 If the engine is running: Release the park- ing brakes or put the transmission in gear. The display will flash the current sleeper temperature and the previous mode (cool- ing or heating) selected. If the cab needs to be cooled or heated, the cool/heat icon will flash. If the engine is not running: Start the en- gine.
Release the parking brakes or put the transmission into gear. 5.2 Let the engine return to base idle. The active light will turn off. Optimized Idle is now disabled and all the DDEC features are available. 2.3 Choose either cool or heat by pressing the Cool/Heat button. Make sure the selection matches that of the cab controls. IMPORTANT: If the heat or cool selection of the thermostat does not match that of the cab, the system will idle and cycle exces- sively. Engine Shutdown Caterpillar CAUTION 2.4 Select Fahrenheit or Celsius by pressing and holding the Mode button until either the "F" or "C" is displayed.
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components. Ex- cessive temperatures in the turbocharger center- housing will cause oil coking problems. Follow the procedure, outlined below, to allow the en- gine to cool. 2.5 Select the temperature set point by press- ing either the Up button or the Down but- ton, as applicable. Holding the button will cause the display to count up or down rapidly. When the desired set point is dis- played, release the button. The set point is stored in memory. 1. With the vehicle stopped, apply the parking brakes. Reduce the engine speed to low idle.
2.6 Select the temperature comfort zone by pressing the Mode button until the upper and lower temperature limit icon is dis- played. Then use the Up or Down button to select one of the three comfort zones of 4°F (2°C), 7°F (4°C), or 10°F (6°C). 2. Place the transmission shift lever in neutral. 3. If the engine has been operating at low loads, run it at low idle for 30 seconds before stopping. If the engine has been operating at highway speed or at high loads, run it at low idle for three minutes to reduce and stabilize internal engine temperatures before stopping. 3. To change the display to either Fahrenheit or Celsius, press the Modebutton until only the F° or C° icon is flashing.
Press the Up or Down but- ton to change to the desired value. The main display will appear five seconds after the button is released. 4. Turn off the ignition key to shut down the engine. 5. If equipped with an idle shutdown timer, it can be set to shut the engine down after a preset amount of time. Ninety seconds before the pre- set shutdown time, the CHECK ENGINE light will begin to flash at a rapid rate. If the clutch pedal or service brake indicates position change during this final ninety seconds, diagnostic lamp flash- ing, the idle shutdown timer will be disabled until reset. 4.
To deactivate the thermostat mode and return to just the engine mode, press the Mode button and hold it for three seconds. 5. To shut down Optimized Idle completely, either turn off the ignition or use the drive away feature. 6. After stopping the engine, fill the fuel tank. 7.18