Freightliner FLD Conventional — FLD Conventional

Engines and Clutches 7. Check the crankcase oil level while the engine is stopped. Maintain the oil level between the ADD and FULL marks on the dipstick. fore, all moving parts of the engine will suffer from poor lubrication. 4. If the engine is not being used, shut it down by turning the ignition key off. 8. If freezing temperatures are expected, allow the engine jacket water expansion tank to cool, then check the coolant for proper antifreeze protec- tion. The cooling system must be protected against freezing to the lowest expected outside temperature. Add permanent-type antifreeze, if required. For additional information, see Group 20 of the Heavy-Duty Trucks Maintenance Manual.

CAUTION Stop the engine at the first sign of malfunction. Almost all malfunctions give some warning to the operator before significant damage occurs. Many engines are saved because alert operators heed the warning signs (sudden drop in oil pressure, unusual noises, etc.) and immediately shut down the engine. 9. Repair any leaks, perform minor adjustments, tighten loose bolts, etc. Observe the vehicle mile- age or the service meter reading, if so equipped. Perform periodic maintenance as instructed in the Lubrication and Maintenance Chart in the Caterpillar Operation and Maintenance Manage- ment Manual. Detroit Diesel 1.

With the vehicle stopped, apply the parking brakes, and place the transmission in neutral. Cummins 2. Allow the engine to run at half speed or slower, with no load, for four to five minutes to cool the engine gradually and uniformly. 1. With the vehicle stopped, apply the parking brakes and place the transmission in neutral. 3. Shut down the engine by turning the ignition key off. 2. It is important to idle an engine three to five min- utes before shutting it down. This allows the lu- bricating oil and the water to carry heat away from the combustion chamber, bearings, shafts, etc. This is especially important with turbo- charged engines.

High-Altitude Operation Cummins Bearings and seals in the turbocharger are sub- jected to the high heat of combustion exhaust gases. While the engine is running, this heat is carried away by oil circulation, but if the engine is stopped suddenly, the turbocharger tempera- ture may rise as much as 100°F (56°C). The ex- treme heat may cause bearings to seize or oil seals to leak. Engines lose horsepower when operated at high alti- tude because the air is too thin to burn as much fuel as at sea level. This loss is about three percent for each 1000 feet (300 m) altitude above sea level for a naturally aspirated engine.

Most turbocharged en- gines are rated for higher altitudes than naturally as- pirated engines. An engine will have smoky exhaust at high altitudes unless a lower gear is used. The engine will not demand full fuel from the fuel system unless the engine is altitude-compensated by the use of a turbocharger. Shift gears as needed to avoid excessive exhaust smoke. 3. Do not idle the engine for excessively long peri- ods. Long periods of idling are not good for an engine because the combustion chamber tem- peratures drop so low the fuel may not burn completely. This will cause carbon to clog the injector spray holes and piston rings, and may result in stuck valves.

If the engine coolant temperature becomes too low, raw fuel will wash the lubricating oil off the cylinder walls and dilute the crankcase oil; there- 7.19