Engines and Clutches Bendix Cruise Control System, Optional General Information 2.2 Depress the brake pedal, or 2.3 Allow vehicle speed to drop below 20 mph (32 km/h). To resume the preselected cruise speed, briefly push the SET/RESUME switch to RESUME. Cruise will return to the last speed selected. The Bendix cruise control system has two modes of operation: cruise control and stationary throttle con- trol. The cruise control mode maintains a driver- selected speed above 20 mph (32 km/h). The sta- tionary throttle control mode provides operator control of the engine throttle position when the ve- hicle is parked. NOTE:
The resume vehicle speed memory is not maintained if the ignition is shut off or if the ON/OFF switch is flipped to OFF. Cruise Control Operation Cruise speed can be adjusted up or down by push- ing the RESUME (accelerate) or SET (decelerate) switch until the desired speed is reached. The cruise control is activated by the ON/OFF and SET/RESUME switches. See Fig. 7.5 . A light in the warning and indicator light module is on when the cruise control is engaged. The vehicle can be accelerated normally with the cruise control engaged. Depress the throttle pedal as needed. When the throttle pedal is released, the ve- hicle will return to the set cruise speed.
WARNING Shifting can be done normally with the cruise control engaged. When the clutch pedal is depressed, the cruise control disengages, allowing the shift to be completed. When the clutch pedal is released, the cruise control reengages, and adjusts engine rpm to return to the selected speed. Do not use the cruise control system when driv- ing conditions do not permit maintaining a con- stant speed, such as in heavy traffic or on roads that are winding, icy, snow covered, slippery, or roads with a loose driving surface. Failure to fol- low this precaution could cause a collision or loss of vehicle control, possibly resulting in per- sonal injury or property damage.
Stationary Throttle Control Operation This mode is used when the vehicle is parked, and is engaged by operating the ON/OFF and the SET/ RESUME switches ( Fig. 7.5 ) as follows: CAUTION Do not attempt to shift gears without using the clutch when the cruise control is engaged. Fail- ure to follow this precaution will result in a tem- porarily uncontrolled increase in engine speed; transmission damage and gear stripping could result. 1. With the engine idling, flip the ON/OFF switch to ON. A light in the warning and indicator light module will come on. 2. Depress and release the RESUME switch until the desired rpm is reached. NOTE:
It may be necessary to depress and re- lease the switch several times before engine speed increases. 1. To cruise at a particular speed: 1.1 Flip the ON/OFF switch to ON. 3. To reduce engine rpm, depress and release the SET switch until the desired rpm is reached. 1.2 Accelerate to the desired speed. 1.3 Push the SET/RESUME switch to SET. NOTE: The cruise control will not work below 20 mph (32 km/h). 4. To disengage the stationary throttle control: 4.1 Flip the ON/OFF switch to OFF, or 4.2 Depress the clutch pedal. 2. To disengage the cruise control: IMPORTANT: In the throttle control mode, engine speed is controlled by positioning the 2.1 Flip the ON/OFF switch to OFF, or 7.20