Freightliner FLD Conventional — FLD Conventional

Engines and Clutches engine throttle linkage. Engine governor characteristics and engine temperature may cause engine speed to vary. Don’t leave the vehicle unattended for long periods of time while the stationary throttle control feature is being used. To engage the engine brake, one or both of the dash switches must be on (up), and both the clutch and throttle pedals must be fully released. To disengage the engine brake, depress the throttle or clutch pedal, or turn both dash switches off (down). De- pending on the engine type, dual dash switches en- able the driver to operate the engine brake at one- third, two-thirds, and full capacity or at half and full capacity.

Engine Braking System, Optional Jacobs Engine Brake WARNING A Jacobs engine brake is a hydraulic-electric engine attachment that converts a diesel engine into an air compressor. This is done by changing engine ex- haust valve operation; it engages or disengages in less than one-fourth of a second. An engine brake is not a substitute for a service braking system, except in emergencies. Do not use the engine brake to shift gears. Using the engine brake to shift gears could result in loss of vehicle control, possibly causing personal injury and property damage. Since the engine brake is most effective at rated en- gine speed, gear selection is very important.

Gearing down the vehicle within the limits of the rated engine speed makes the engine brake more effective. Maxi- mum braking occurs with the use of the lowest gear that does not exceed the rated engine speed. A rule of thumb for gear choice is to select the gear that normally would be used to climb an approaching downhill grade. Generally, this same gear can be used with the engine brake for a controlled descent of the hill. The controls consist of: dual dash switches ( Fig. 7.10 ), which are on/ off toggle switches; "Control speed" is the speed at which the engine brake performs 100 percent of the required downhill braking, resulting in a constant speed of descent.

The control speed varies, depending on vehicle weight and the downhill grade. f600087 08/20/93 Fig. 7.10, Engine Brake Switches For faster descent, select a higher gear than that used for control speed. Service brakes must then be used intermittently to prevent engine overspeed and to maintain desired vehicle speed. a clutch switch, which is a transmission- mounted microswitch that actuates when the driver removes his foot from the clutch pedal; a throttle switch, which is an engine-mounted microswitch that actuates when the driver re- moves his foot from the throttle pedal. IMPORTANT:

When descending a grade, re- member that frequent use of service brakes causes them to become hot, which results in a reduction of their stopping ability. Grade descent speed should be such that the service brakes are used infrequently and that they remain cool, thus retaining their effectiveness. Jacobs Engine Brake Operation WARNING Do not use the engine brake if road surfaces are slippery. Using the engine brake on wet, icy, or snow-covered roads could result in loss of ve- hicle control, possibly causing personal injury and property damage. A driver may descend slower than control speed by selecting a lower gear, one that will not overspeed the engine.

The engine brake retarding force will then be sufficient to cause vehicle deceleration. Oc- casional deactivation of the engine brake may be 7.21