Freightliner FLD Conventional — FLD Conventional

Engines and Clutches necessary to maintain the designated road speed under these conditions. 4. When either the clutch or throttle pedal is de- pressed, the engine brake is deactivated. The engine brake can be used to stop a vehicle if the service brakes quit working. By energizing the engine brake as soon as a service brake problem is apparent, a retarding effect is applied to the vehicle. As grade conditions permit, the driver can progres- sively downshift, using the engine brake in each gear. Eventually the engine brake will stop the ve- hicle.

CAUTION If the engine brake fails to shut off when either the throttle or clutch pedal is depressed, place the dash switch in the OFF position and do not use the engine brake until the throttle or clutch switch system is repaired. If the engine brake fails to shut off when the dash switch is turned off, the engine should be shut down and the en- gine brake repaired before continuing operation. Failure to do so could result in damage to the engine. WARNING Using the engine brake as a primary braking sys- tem when the service brakes are operable is dan- gerous. This can cause long, unpredictable stop- ping distances, possibly resulting in personal injury or property damage.

Clutches General Information Whenever vehicle braking is required, the engine brake may be used with the service brakes. There is no time limit for operation of the engine brake. The major reason why clutches wear out too soon is excessive heat. Clutches are designed to absorb and dissipate more heat than encountered in typical op- eration. The temperatures developed in typical op- eration will not break down the clutch friction sur- faces. However, if a clutch is slipped excessively or asked to do the job of a fluid coupling, high tempera- tures develop quickly and destroy the clutch.

Tem- peratures generated between the flywheel, driven discs, and pressure plates can be high enough to cause the metal to flow and the friction facing mate- rial to char and burn. 1. After the engine is warmed up and the vehicle is in motion, turn on the dash toggle switches (up position). On vehicles equipped with a Cummins NTC en- gine, select either the left-side switch (one-third engine brake retarding capacity), the right-side switch (two-thirds engine brake retarding capac- ity), or both switches (full engine brake retarding capacity).

On vehicles equipped with a Cummins L10 or Caterpillar engine, select either the left-side switch or right-side switch (for one-half engine brake retarding capacity), or both switches (for full engine brake retarding capacity). Heat and wear are practically nonexistent when a clutch is fully engaged. But during the moment of engagement, when the clutch is picking up the load, it generates considerable heat. An improperly ad- justed or slipping clutch will rapidly generate suffi- cient heat to destroy itself. 2. The engine brake activates when the driver’s feet are removed from both the clutch and throttle pedals.

If it fails to activate, stop the vehicle in a safe spot and check the adjustment of the throttle and clutch switches. If no cause can be detected in the electrical system, check the en- gine brake system. See Group 01 of the Heavy- Duty Trucks Service Manual for instructions. The most important items that a driver should be aware of to ensure long service life of the clutch in- clude: starting in the right gear, clutch malfunctions, and when to adjust a clutch. Clutch Operation Eaton Valeo Clutch Break-In 3. To obtain maximum retarding, maintain the top governed speed of the engine through appropri- ate selection of gears when the engine brake is in use.

With a newly installed Eaton Valeo clutch, the clutch may slip for a short time while the friction surfaces break-in. However, allowing the clutch to slip for more than two seconds can severely damage the clutch disc, pressure plate, and the flywheel. 7.22