Engines and Clutches During initial operation of a new vehicle or a vehicle with a new clutch, check for clutch slippage during acceleration. If the clutch slips, decelerate until the clutch does not slip. Allow the clutch to cool 15 to 30 seconds and then gradually accelerate again. If the clutch continues to slip, repeat the procedure. If nec- essary, repeat the procedure up to five times. If the clutch slips after five attempts, stop the vehicle. Allow the clutch to cool for at least one hour. Notify your Freightliner dealer of the problem. transmission still in gear, a reverse load will be put on the gear.
At the same time, it will have the effect of trying to stop or decelerate the vehicle with the clutch brake. Rapid wear of the friction discs will take place necessitating frequent re- placement. Considerable heat will be generated, which will be detrimental to the release bearings and transmission front bearings. Excessive Vehicle Overload, or Overloading the Clutch CAUTION Clutches are designed for specific vehicle applica- tions and loads. These limitations should not be ex- ceeded. Do not allow sustained slippage of the clutch; this could severely damage the clutch disc, pres- sure plate, or flywheel. Damage caused by clutch slippage due to improper break-in is not warrant- able.
CAUTION Starting the Vehicle in the Proper Gear Overloading will not only result in damage to the clutch, but also to the entire powertrain. An empty truck can be started in a higher transmis- sion gear ratio than when partially or fully loaded. A good rule of thumb for the driver to follow is: select the gear combination that allows you to start moving with an idling engine, or, if necessary, just enough throttle to prevent stalling the engine. After the clutch is fully engaged, the engine should be accelerated to the correct rpm for the upshift into the next higher gear.
Riding the Clutch Pedal Riding the clutch pedal is very destructive to the clutch since partial clutch engagement permits slip- page, generating excessive heat. Riding the clutch pedal will also put a constant thrust load on the re- lease bearing, which can thin out the lubricant. Re- lease bearing failures can be attributed to this type of misuse. Gear Shifting Techniques Holding the Vehicle on an Incline With a Slipping Clutch Many drivers upshift into the next gear, or even skip- shift into a higher gear, before the vehicle has reached the proper speed.
This type of shifting is almost as bad as starting off in a gear that is too high since the engine rpm and vehicle speeds are too far apart, requiring the clutch to absorb the speed difference as heat. For transmission operating in- structions, see Chapter 8 in this manual. A slipping clutch accumulates heat faster than it can be dissipated, resulting in early clutch failures. Never use the clutch as a hill holder. Coasting With the Clutch Released (Pedal Depressed) and the Transmission in Gear The clutch brake is applied by fully depressing the clutch pedal.
Its purpose is to stop the transmission gears from rotating in order to engage the transmis- sion gears quickly in making an initial start. Coasting with the clutch released and the transmis- sion in gear can cause high driven disc rpm through multiplication of ratios from the final drive and trans- mission. CAUTION WARNING Never apply the clutch brake when making down- shifts or upshifts. The clutch pedal should never be fully depressed before the transmission is put in neutral. If the clutch brake is applied with the Do not coast with the clutch released (pedal de- pressed) and the transmission in gear. High driven-disc rpm could cause the clutch facing to 7.23