Hino J08C-TP, J08C-TR — INSTALLATION OF THE ENGINE COMPONENT PARTS

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-17-3 2. Install the exhaust manifold onto the cylinder head and tighten the inner mounting nuts (WAF 17 mm) in the order shown in the figure to the specified torque below. Tightening torque: 540 kg·cm (39 lb·ft) 3. Tighten the same nuts according to the same proce- dure again. Tightening torque: 540 kg·cm (39 lb·ft) NOTE: Be sure to carry out the tightening order proce- dure. 4. Tighten the outer mounting nuts (WAF 14 mm), in the order shown in the figure, to the specified torque below. Tightening torque: 620 kg·cm (45 lb·ft) NOTE: Be sure to hold the inner nut when tightening the outer nut. 7. INSTALL THE OIL COOLER. 1.

Clean the cylinder block mounting surface of oil cooler. 18 17 16 15 14 13 12 11 10 9 8 7 TIGHTENING ORDER…NEW MANIFOLD 1 2 3 4 5 6 14 15 8 9 2 3 5 6 11 12 17 18 TIGHTENING ORDER…REUSED MANIFOLD 13 7 1 4 10 16 SM3-J034 Fig. 9 MATCHING FLANGE FACE WITH BLOCK LIQUID GASKET SM3-J034 Fig. 10 2. Insert the D-ring into the D-ring groove of the oil cooler. NOTE: Face the flat area of the D-ring toward the oil cooler for installation. ALTERNATOR EARTH 3. Apply liquid gasket to the oil cooler housing and in- stall it onto the cylinder block within 20 minutes. 4. Install the oil line. Liquid gasket: ThreeBond No. 1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE:

D-RING G If more than 20 minutes have passed since the liquid gasket was applied, do not assemble. After removing the liquid gasket completely, reapply it to assemble. G When installing the oil cooler, the earth wire of alter- nator must be tightened with the coolant pipe bracket for turbocharger. G Refer to page 3-20-1. BLOCK D-RING OIL COOLER PLANE PART SM3-J166 Fig. 11