Hino J08C-TP, J08C-TR — INSTALLATION OF THE ENGINE COMPONENT PARTS

1 page 1 3-17-4 ENGINE Models J08C-TP and J08C-TR 8. INSTALL THE OIL FILTER ELEMENT. 1. Apply engine oil to the gasket of oil filter element, and tighten the element by hand until the gasket contacts the body. 2. Tighten the oil filter element 3/4 turn to one turn from the condition of step 1. Special tool: Oil filter wrench (09553 - 1021) SM3-J606A Fig. 12 9. INSTALL THE TURBOCHARGER. NOTE: Refer to TURBOCHARGER in CHAPTER 51. SM3-J615 Fig. 13 FLYWHEEL HOUSING 10. INSTALL THE AIR COMPRESSOR. 1. Match the No. 1 cylinder to the top dead center of compression stroke. NOTE: Refer to page 3-18-1. FLYWHEEL Fig. 14 SM3-J202 PROJECTION 2.

Match the projection of the air compressor housing with the opposite side of the tooth with the drive gear alignment mark (original Hino mark). a MATCH MARK “ H ” 3. Place a guide stud bolt (M8 x 1.25, length: 50 mm (1.968 in) or more) in the flywheel housing as shown in the figure and insert the compressor onto the stud bolt. NOTE: Applying excessive force to the air compressor may damage the mounting spigot or may cause oil leakage due to flaking of liquid gasket between the flywheel housing and plate. 4. Tighten the mounting bolts (other than the stud bolt), then remove the stud bolt. Insert a bolt in the place of the stud bolt. MATCH MARK “ H ” Fig. 15 SM3-J220 STUD BOLT 5.

Install the oil lines, cooling lines and air lines. Fig. 16 SM3-J221