1 page 1 Models J08C-TP and J08C-TR ENGINE 3-17-5 11. INSTALL THE INTAKE MANIFOLD. LOBE SM3-J106 Fig. 17 12. INSTALL THE INTAKE PIPE. 1. Clean the matching face of intake manifold and the intake pipe. 2. Apply liquid gasket to the intake manifold and install it onto the cylinder head within 20 minutes. Liquid gasket: ThreeBond No. 1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: If more than 20 minutes have passed since the liquid gasket was applied, do not assemble. Af- ter removing the liquid gasket completely, reap- ply it to assemble. NOTE: Refer to page 3-20-1. MATCHING FACE WITH INTAKE MANIFOLD LIQUID GASKET SM3-J038 Fig. 18 13. INSTALL THE FUEL INJECTION PUMP. 1.
To adjust the injection timing, turn the flywheel in the rotation direction (counterclockwise viewed from the flywheel side). Injection timing:3° before top dead center in the compres- sion cycle. NOTE: Refer to page 3-18-1. FLYWHEEL HOUSING FLYWHEEL SM3-J202 Fig. 19 2. Turn the injection pump timer counterclockwise slowly viewed from the coupling (normal direction of engine) and align the mark on the timer with the mark on the injection pump. 3. Put the injection pump on the pump bracket and tighten the injection pump mounting bolt evenly to the torque below. Tightening torque: 950 kg·cm (68 lb·ft) 4. Tighten the flange bolt using the special tool. Tightening torque:
950 kg·cm (68 lb·ft) Special tool: Injection pump coupling wrench (09511 - 2500) 5. Tighten the cotter bolt at the flange. Tightening torque: 950 kg·cm (68 lb·ft) COUPLING COTTER BOLT FLANGE BOLT TIMER SM3-J740 Fig. 20