Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-6-17 2. Measure the outside diameter of the rocker arm shaft with a micrometer. If wear exceeds the service limit, replace the rocker arm. Nominal dimension: 22.0 mm (0.8661 in.) Service limit: 21.92 mm (0.8630 in.) 3. Calculate the clearance between the rocker arm bushing and rocker arm shaft. If the clearance is greater than the specified limit, replace the rocker arm bushing. SM3-J641 Fig. 57 Assembly standard: 0.03 - 0.101 mm (0.0012 - 0.0039 in.) Repair limit: 0.15 mm (0.0059 in.) INSPECT THE ROCKER ARM AND CROSS HEAD. Visually check the contact between the rocker arm and cross head.

Replace the rocker arm and the cross head if damage such as wear and scratches is excessive. If there is only a minimal amount of wear, correct the sur- face with a resurfacer. Visually check the adjusting screw thread. Replace the adjusting screw if damage such as wear and scratches is excessive. SM3-J642 Fig. 58