1 page 1 Models J08C-TP and J08C-TR 3-6-18 ENGINE ASSEMBLING ASSEMBLE THE VALVE SYSTEM. NOTE: If parts are reused, install them to their initial position. 1. Apply engine oil to the intake and exhaust valve stems. Then insert them to the valve guide installed to the cylinder head. 2. Install the valve inner and outer springs and valve spring seat upper. 3. Press fit the valve spring seat upper with the special tool, then securely fit the valve spring retainer. Special tool: Valve spring press (09470 - 1022) SM3-J060 Fig. 59 ASSEMBLE THE ROCKER ARM ASSEMBLY. 1. Make sure of the correct direction of the rocker arm support and assemble the rocker arm assembly. NOTE:
Wrong mounting of the rocker arm support results in seizure of the valve mechanism due to incor- rect lubrication. 2. Wind up the adjusting screw of the rocker arm com- pletely. NOTE: If the adjusting screw is left unwound, the rocker shaft may bend when the rocker arm support is tightened. SM3-J643 Fig. 60 INSTALL THE CAM IDLER GEAR. 1. Install the cam idler gear with the snap ring side fac- ing the cylinder head. 2. Install the cam idler gear shaft through a thrust plate, with the oil filler facing downward. NOTE: Refer to page 3-6-1. 3. Tighten the idler gear shaft bolt to the specified torque below. Tightening torque: 1,100 kg·cm (80 lb·ft) SM3-J644 Fig.
61 MEASURE THE CAM IDLER GEAR END PLAY. After installing the cam idler gear, measure the clearance between the cam idler gear and thrust bearing with a dial gauge. If the clearance exceeds the service limit, replace the thrust bearing. Nominal clearance: 0.040 - 0.095 mm (0.0016 - 0.0037 in.) Service limit: 0.30 mm (0.0118 in.) SM3-J645 Fig. 62