OPERATION MONITOR PANEL MODE SELECTOR SWITCH 1 This switch (12) is used to switch the function of the character display. When the switch is released, it automatically returns to its original position. The basic operation is as follows. Position ( ‘ ): press to select or confirm each mode or operation. Position ( „ ): press to cancel each mode or operation. MONITOR PANEL MODE SELECTOR SWITCH 2 This switch (13) is used to switch the function of the character display. When the switch is released, it automatically returns to its original position. The basic operation is as follows. Position (>):
Press here to go to the next screen, or to move the cursor forward, or to increase the number when entering numerals Position ( cursor back, or to reduce the number when entering numerals KICKDOWN SWITCH When the gearshift lever is in 2nd, if switch (14) on the head of the left arm control lever is pressed, the transmission will shift down to 1st. This switch is used to increase the drawbar pull in digging operations. If the transmission is in auto-shift, and the travel speed is below 12.5 km/h (7.8 mph) in any speed range when traveling in either forward or in reverse, the kick-down switch is actuated and it is possible to shift down to 1st.
This makes it easy to perform load and carry operations. Even if the travel speed is more than 12.5 km/h (7.8 mph), this switch can be used to shift the transmission down. Each time the kick-down switch is pressed, the speed range will shift down one range at a time (F4 F3 F2). When the torque converter is in the lock-up condition (if equipped), the lock-up is canceled. Remark When canceling the kick-down, operate the directional lever. In manual shift, the kick-down can be canceled by operating the gearshift lever to any position other than 2nd. It is also possible to cancel the kick-down by turning the ignition switch “OFF”.
In auto-shift, if the travel speed becomes high after the kick-down, the gear will be shifted up by the auto-shift. In auto-shift, when traveling at more than 25 km/h (15.5 mph) in 3rd or at more than 35 km/h (21.7 mph) in 4th, even if the kick-down switch is pressed, the transmission will not shift down. This is to prevent overrun of the engine. 2-38 WA480-5L