Transmissions 3. Do not make range shifts with the vehicle moving in reverse gear. R R R 5 7 1 3 4. Never attempt to move the range preselection lever with the gear shift lever in neutral while the vehicle is moving. Preselection with the range preselection lever must be made prior to moving the shift lever out of gear into neutral. N 4 LO 6 8 LO−LO 2 5. Do not shift from high range to low range at high vehicle speeds. 03/12/96 f260123a 6. Use double-clutching between all upshifts and downshifts that require movement of the shift lever. Fig. 5.8, Shift Pattern, Deep Reduction 7. After your shifting ability improves, you may want to skip some of the ratios.
This may be done only when operating conditions permit, depending on the load, grade, and road speed. CAUTION Never use the clutch brake when downshifting, or as a brake to slow the vehicle. This will cause pre- mature clutch brake wear. Operation, 9-Speed Models Upshifting 2. Use the clutch brake to stop gear rotation when shifting into low (or 1st) or reverse when the vehicle is stationary. The clutch brake is applied by de- pressing the clutch pedal all the way to the floor. 1. Position the gear shift lever in neutral. See Fig. 5.4 for the shift pattern. Start the engine, and bring the air system pressure up to 95 to 125 psi (655 to 862 kPa).
For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. 2. Position the range preselection lever down into low range. 5.5