Freightliner Business Class — Business Class Driver's Manual

Transmissions section. The driver must use the clutch to start and stop the vehicle. CAUTION Do not attempt a lever only downshift at too high of an engine speed (generally above 1000 rpm). Doing so could result in damage to the engine, transmis- sion, and/or driveline. When conditions are right for a shift, the transmission Electronic Control Unit (ECU) notifies the driver with a tone from the Driver Command Console (DCC). See Fig. 5.11 . The driver, when ready to shift, breaks torque and the transmission goes to neutral. The driver then either increases or decreases engine speed to synchro- nize the shift. When engine speed is correct, the trans- mission shifts automatically. 3.

Lever-only shift—Break torque by releasing the throttle and depressing the clutch pedal. Double- clutching, move the shift lever to the next desired gear position. The lever-only shift is used to skip a full gear. With the shift button rearward—9th to 7th, 7th to 5th, 5th to 3rd, and 3rd to 1st. With the shift button forward—10th to 8th, 8th to 6th, 6th to 4th and 4th to 2nd. The AutoSelect system consists of the following compo- nents. The Driver Display Module, or DDM ( Fig. 5.12 ), mounted on the dashboard, indicates gear posi- tion and the direction engine rpm needs to go for the next gear engagement.

When the gear select lever is in the "D" position, the display module indicates what the driver must do to engage the next gear (decelerate or accelerate) by down and up arrows. When the gear number is solid on the display, that gear is fully engaged. When the gear number is flashing the transmission is either out of gear, waiting for the engine and transmission to synchronize, or the next gear engagement is in process. NOTE: Never use the clutch brake when down- shifting, or as a brake to slow the vehicle. Eaton Fuller AutoSelect Automated Transmissions General Information, AutoSelect 10-Speed RTAO Models Eaton Fuller 10-speed RTAO models have 10 forward speeds and two reverse speeds.

The transmission con- sists of a five-speed front section and a two-speed rear The Driver Command Console, or DCC ( Fig. 5.11 ), replaces the shift lever and controls the transmission’s shift patterns. There are indicators 5.14