Freightliner Business Class — Business Class Driver's Manual

Fifth Wheels 12. The load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle. 3. Chock the front and rear of the trailer tires to pre- vent the trailer from moving. Determine the front and rear axle weights by weigh- ing the vehicle on scales designed for this purpose. WARNING Do not use the trailer air supply for parking trailers not equipped with spring parking brakes. This ap- plies the trailer service brakes only. As air bleeds from the trailer brake system, brake application is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death.

The maximum axle weight ratings are given on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no case should the axle load exceed the maximum axle weight rating given on the FMVSS or CMVSS label. 4. Lower the trailer landing gear until the weight is re- moved from the fifth wheel. WARNING 5. Disconnect the tractor-to-trailer air system lines and electrical cable. Plug the air lines to prevent dirt or foreign material from entering the lines.

Do not overload any tractor axle by improperly loading the trailer. This could cause erratic steering and loss of vehicle control, possibly resulting in serious personal injury or death. 6. Release the kingpin locking mechanism by lifting the safety latch and pulling the lock control handle to the unlocked position. See Fig. 8.8 . 7. Slowly drive the tractor away from the trailer. Unlocking the Fifth Wheel Lock Mechanism 1. Apply the tractor parking brakes. 2. Pull the trailer air supply valve to cut off the air sup- ply to the trailer.

CAUTION Before attempting to lock or unlock the fifth wheel lock mechanism of a sliding type fifth wheel, the slide release pull handle, if so equipped, and the 8.11