Pretrip Inspection and Daily Maintenance For vehicles with a trailer air brake hooku- p,release the parking brakes on the vehicle by pushing in the parking brake control valve knob. See Fig. 9.17 . Apply the trailer parking brakes by pulling out the trailer air supply valve knob. See Fig. 9.17 . 1 With the air system fully charged to 125 psi (862 kPa), make one full brake application and note the air pressure reading on the gauge. Continue to reduce the air pressure by moderate brake applications to a maxi- mum of 90 psi (620 kPa), then run the en- gine at governed rpm.
If the time required to raise the air pressure to 125 psi (862 kPa) (from the pressure noted after one brake application) is more than 30 seconds, elimi- nate any leaks or replace the air compressor before operating the vehicle. 2 1. Parking Brake Control Valve Knob 2. Trailer Air Supply Valve Knob f600372 45.3 Check the air pressure reserve. With the air system fully charged to 125 psi (862 kPa), stop the engine and note the air pressure. Then make one full brake application and observe the pressure drop. If it drops more than 25 psi (172 kPa), all areas of leakage must be eliminated before operating the ve- hicle. Fig.
9.17, Parking Brake Valve and Trailer Air Supply Valve Knobs the trailer-brake system with air by pushing in the trailer air supply valve knob). With the parking brakes applied, the trans- mission out of gear, and the tires chocked, 45.4 Check the air leakage in the system (on ve- hicles with a trailer air brake hookup, charge 9.33