. OPERATION OPERATION OPERATION OPERATION and run the (a) (b) (c) RAISE HOLD LOWER (d) (e) (f) FLOAT LEFT TILT RIGHT TILT 5. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. 3 - 99 1. IDLE (MIN ) and HIG H IDLE (MAX) medium s peed for abo ut 5 minutes wi LOW engi at 2. Blade con trol lever (2) to the full RAIS E position, the n ho ld the lever in po sition, and o perate slowly to the left tilt relief and right tilt relief p ositions for 5 minutes. 3. Finally, op to operate erate blade the blade a control lever (4) nd ripper cylind and ripper control ers several times.
lever If the oil t raised, th emperature ere will be a in the work equipment is not properly time lag in the response of the work g. equipmen t and steerin 4. After warm -up is completed, check ga uges and caution l amps for proper operation. If any problem is found, repair i t. til engine Continue ngine under a light load un ngine coolant te green range (B). (A): White (B): Green (C): Red r REMARK If the power tra in oil temperature is not rais ed sufficiently, i t wil l take longer to acce lerate to the maximum spe ed.