MAN — Removing and installing cylinder head

Removing and installing cylinder head Fig. 5 Remove cylinder head bolts in reverse order of tightening. Note: Use reinforced socket (screw-driving ma- chine) to loosen and tighten the cylinder head bolts. On engines recently manufactured Torx bolts are used for which an E20 − Ѕ wrench is required. 5 Fig. 6 Remove the mounting bolts from the intake and exhaust pipes for the respective cylinder head. Loosen all mounting bolts of intake manifold and exhaust pipe. This will reduce the tension on the cylinder head, and the head can be taken off more easily. 6 Fig. 7 Take off cylinder head and cylinder head gasket. Note:

If within the context of an engine overhaul all cylinder heads of a bank are removed, check the sealing faces of the cylinder heads and of the cylinder block with a straight edge to see whether they are plane. Cylinder heads which are not plane may be remilled by 1 mm. Observe specified nozzle protrusion and valve retrusion (see “Engineering S Data and S Setting values”). Check the cylinder heads for cracks. 7 8 105