MAN — Removing and installing cylinder head

Removing and installing cylinder head Installing cylinder head Fig. 8 Before installation clean and blow out threaded bores in crankcase. Clean sealing faces on cylin- der head and crankcase. Lay new cylinder head gaskets in place in dry condition, ensuring that the holes match those in the crankcase, and place cylinder head on top. 8 Fig. 9 Each cylinder head is located with two fitting sleeves. Fig. 10 Check whether the cylinder head bolts have the max. permissible length (see: ”Engineering, data and setting values”). Bolts that have been removed may be used again if the max. permissible length is not exceeded.

9 Coat cylinder head bolts with engine oil before in- serting them and apply ”Optimoly WhiteT” assem- bly paste to the contact face of the bolt head. Fig. 11 Tighten bolts by angle. Observe order of tightening and specified tightening method, and see instruc- tions and notes on the cylinder head bolts in the publication “Engineering S Data S Setting values”. Note: To avoid any distortion between cylinder heads and exhaust manifolds, we recom- mend proceeding as follows: D Place cylinder head gaskets and cylin- der heads in position. D Screw in head bolts by a few turns. D Secure steel ruler (special tool) with ground face on the exhaust side; tight- ening torque for mounting bolts: 20 Nm.

If a steel ruler is not available, mount exhaust manifold and tighten to 20 Nm. D Tighten cylinder head bolts as speci- fied. D Remove steel ruler. D Tighten exhaust manifold and intake manifold to specified torque. 10 11 106