24. SERVICE PROCEDURE 24.8.8 REPLACE CORROSION RESISTOR CARTRIDGE 1. Open the engine side cover located on the right of the engine hood. 2. Screw in valve 1 at the side of the corrosion resistor. 3. Using the filter wrench provided, remove cartridge 2 by turning it counterclockwise. 4. Coat the seal surface of the new cartridge with engine oil, and install it to the filter holder. 5. When installing, bring the gasket into contact with the seal surface of the filter holder, then tighten approx. 2/3 turns. 6. After replacement, open valves 1 . After replacing the cartridge, start the engine and check that there is no leakage of water from the filter seal surface. 3-74