24. SERVICE PROCEDURE 2. Remove rear oil filler plug 1 , then remove drain plug 2 to drain the oil. 3. Remove drain plug 3 to drain the oil. 4. Stop the machine so that drain plug 4 of the final drive is at the bottom. Remove oil filler plug 5 and drain plug 4 , and fit the tube of attached tool in hole of plug 4 and drain the oil. 5. After draining the oil, clean drain plugs 2 , 3 and 4 , then install them. 6. Add oil to the specified level through the oil filler ports 1 and 5 of the axle housing and left and right final drives. For details of the oil to use, see “20. USE OF FUEL AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 7.
After adding oil, check that the oil is at the specified level. For details, see “24.2 WHEN REQUIRED”. REMARK For operations where the brake is used frequently, change the axle oil at shorter intervals. 24.9.5 REPLACE AIR CONDITIONER FILTER (IF EQUIPPED) Remove both the recirculation air filter and fresh air filter in the same way as when cleaning, and replace them with new parts. For details of cleaning the recirculation air filter, see “24.6.4 CLEAN ELEMENT IN AIR CONDITIONER RECIRCULATION FILTER”. For details of cleaning the fresh air filter, see “24.5.3 CLEAN ELEMENT IN AIR CONDITIONER FRESH AIR FILTER”. 3-81