Komatsu — 24.9 EVERY 2000 HOURS SERVICE

24. SERVICE PROCEDURE 24.9.6 CLEAN PPC CIRCUIT STRAINER 1. Remove 3 bolts 1 of the PPC circuit strainer. 2. Remove the strainer case and pull out the strainer, then wash the strainer with clean diesel fuel. 3. Install the strainer in the strainer case, and install it with bolts 1 . 4. Operate the bucket control lever to the TILT position and the boom control lever to the FLOAT position, and when the cylinder reaches the end of its stroke, hold it there for one minute. 5. Operate the bucket control lever to the DUMP position and the boom control lever to the RAISE position, and when the cylinder reaches the end of its stroke, hold it there for one minute. 6.

Bleed the air from the hydraulic circuit. For details, see “24.2 WHEN REQUIRED”. For details of the procedure for bleeding air from the hydraulic circuit, please contact your Komatsu distributor. 3-82