Komatsu — 36.3 SWITCHING MONITOR SCREEN

36. HANDLING MULTI MONITORING SYSTEM When target production will be exceeded if measured load is loaded onto dump truck 1) The value in remaining value display portion 1 is shown in red with a – mark. After 3 seconds, the display returns to the previous display and changes to yellow. 2) Normally, load weight display portion 2 will return to the 0 ton display 15 seconds after the buzzer sounds after measurement, but in this case, the load in the bucket continues to be displayed.

3) Judge the load in the bucket to the target production from the display for the remaining amount to the target production in remaining value display portion 1 and the display for the load in the bucket in load weight display portion 2 . When values in remaining value display portion 1 and load weight display portion 2 are close (When the whole load inside the bucket is loaded into the dump truck) After loading the dump truck, press the figures, sub-total switch or bucket control lever sub-total switch for at least 2 seconds, and print out the amount loaded into the dump truck.

The target production is displayed in remaining value display portion 1 , and the preparations for loading the next dump truck are completed. When displays in remaining value display portion 1 and load weight display portion 2 are used to adjust the load in the bucket and the dump truck is loaded After adjusting and loading the dump truck, tilt the bucket back, and lower the boom from the horizontal position (to a position between horizontal and the ground level). Run the engine at a mid-range speed and raise the boom until the buzzer sounds for the completion of measurement. The load remaining in the bucket is subtracted and the remaining amount to the target production is displayed.

Repeating this operation is an effective way of loading accurately to the target production. 5-77