Komatsu — 39.5 ADJUSTING REMOTE POSITIONER

39. HANDLING OF REMOTE POSITIONER 39.3 METHOD OF SETTING REMOTE POSITIONER STOP POSITION 1. When RAISE stop display lamp 1 is lighted up, operate the lift arm control lever to raise the lift arm to the desired height (above horizontal), then return the lift arm control lever to HOLD and press RAISE position set switch 2 . RAISE stop display lamp 1 will go out and RAISE set pilot lamp 3 will flash from 2.5 seconds. When RAISE set pilot lamp 3 goes out and RAISE stop display lamp 1 lights up, the RAISE stop position is recorded 2.

When LOWER stop display lamp 4 is lighted up, operate the lift arm lever to lower the lift arm to the desired height (above horizontal), then return the lift arm control lever to HOLD and press LOWER position set switch 5 . LOWER stop display lamp 4 will go out and LOWER set pilot lamp 6 will flash for 2.5 seconds. 39.4 SENSOR ADJUSTMENT FUNCTION This function offsets the error caused by the mounting of the potentiometer and marks it possible to defect the correct position data for the work equipment. Always carry out this function when replacing the controller potentiometer or work equipment. SENSOR ADJUSTMENT METHOD 1. Set the work equipment to the lift arm top position. 2.

Keep LOWER position set switch 1 and RAISE position set switch 2 pressed at the same time for at least 3 seconds. When LOWER set pilot lamp 3 and RAISE set pilot lamp 4 light up, release the switches and the sensor adjustment mode. 3. The LOWER set pilot lamp 3 and RISE set pilot lamp 4 light up for 2 seconds, and when both lamps go out, the offset is recorded in memory. 4. If the lamps flash in Step 3, the potentiometer output is not within the offset range, so adjust the potentiometer mount. Adjustment can be carried out at the posture in Step 1.

REMARK After adjustment each potentiometer, always carry out Steps 1 and 2 again, and check that condition on Step 3 is correct (the set lamps light up for 2 seconds and then go out. 39.5 ADJUSTING REMOTE POSITIONER When the lift arm has been removed or setting does not work efficiency, please contact your Komatsu distributor for adjustment. 5-113