Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Circuit Breaker 1. Raise the hood and seat assembly. Make sure the support cylinder securely holds the hood open. Typical Example 2. The main circuit breaker is located on the rear of the support for the controls. Fuses are identified as follows : 1. Horn - 10 amp. 2. Head Lamp, Clearance Lamp, Tail Lamp. - 15 amp. 3. Lamp Relay Coil, Fwd/Rev Solenoid, Rear Lamp /Alarm - 10 amp 4. Instrument Panel, Hour Meter, Preheat Controller, Fuel Shut-off Solenoid - 15 amp 5. Stop Lamp, Turn Signal Lamp, Strobe Lamp - 15 amp NOTE : To reset circuit breakers push in on the but- ton. The button should stay in if the breaker is reset.

If the button will not stay in, or comes out shortly after reset, have the circuits checked. Tire and Wheels - Inspect, Check 6. Starter Relay - 10 amp Bulbs Bulbs are identified as follows : 1. Bulb-head lamp halogen (12V-35W) 1. Inspect the thickness of the tread area. It should be more than 25 mm (1 inch). If the thickness is less than 25 mm (1 inch), the tire must be replaced. Consult your DOOSAN dealer. Do not try to replace the tire yourself. 2. Inspect the wheels. They should have no cracks or distortion. *2. Bulb-back up (12V-8W) *3. Bulb-turn signal (12V-23W) *4. Bulb-stop & tail (12V-23/8W) *OPTIONALLAMP OR LIGHT 108