Maintenance section Test Fuel System for Leaks Check Points 1. Obtain a leak check squirt bottle or pump spray bottle. 2. Fill the bottle with an approved leak check solution. 3. Spray a generous amount of the solution on the fuel system fuel lines and connections, starting at the storage container. 4. Wait approximately 15-60 seconds then perform a visual inspection of the fuel system. Leaks will cause the solution to bubble. 5. Repair any leaks before continuing. 6. Crank the engine through several revolutions. This will energize the fuel lock-off and allow fuel to flow to the pressure regulator/converter.
Apply additional leak check solution to the regulator/converter fuel connections and housing. Repeat leak inspection as listed above. 7. Repair any fuel leaks before continuing. Prior to any service or maintenance activity, Test Fuel System for Leaks WARNING 109