Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Wheel Bolts - Inspect Carriage Roller Extrusion – Adjust Inspect Tightness - Drive Wheels 1. Set the mast vertical. 1. Inspect the tightness of the wheel bolts in a sequence opposite each other 135 + 15 N m (100lb ft.). 2. Lower the carriage completely. 3. On full free lift and full free triple lift models, the bottom of the inner mast must be flush with the bottom of the stationary mast. 4. Measure the distance from the bottom of the inner upright to the bottom of carriage bearing. 5. The measurement (A) must be as follows in Chart below. 110 Height of carriage roller extrusion (A) STD mast FF mast FFT mast -6 11 11