volvo — Volvo Trucks Service Manual Group 177-500

Group 170 Preventive Maintenance Cold Check: Note: The fluid level rises as its temperature rises. Do not fill above the Cold Run band if the transmission fluid is below normal operating temperatures. 1 The purpose of the cold check is to determine if the transmission has enough fluid to be operated safely until a hot check can be made. 2 Run the engine for at least one minute. Apply ser- vice brake. Shift to Drive (D) and operate the engine for 30 seconds at 1000 to 1500 rpm; then shift to Reverse (R) to clear the hydraulic system of air. Then shift to Neutral (N) and allow the engine to idle (500 to 800 rpm). 3 With the engine running, remove the dipstick from the tube and wipe clean.

4 Insert the dipstick into the tube and remove. Check the fluid level reading. Repeat the check procedure to verify reading. 5 If the fluid level is within the “COLD RUN” band, the transmission may be operated until the fluid is hot enough to perform a “HOT RUN” check. If the fluid level is not within the “COLD RUN” band, add or drain as necessary to bring it to the middle of the “COLD RUN” band. 6 Perform a hot check at the first opportunity after the normal operating temperature of 71–93 C (160–200 F) is reached. 46