SERIES 40 ENGINE OPERATOR'S GUIDE Ethylene Glycol/Water + OAT Inhibitor or Propylene Glycol/Water + OAT Inhibitor — Ethylene glycol and propylene glycol are also available with a (Organic Acid Technology) corrosion package. These coolants require less maintenance over the useful life of the engine. OAT coolants, maintained as detailed in the Maintenance section of this guide, may be operated up to 4 years, 600,000 miles (960,000 km), or 10,000 operating hours, whichever comes first. Refer to section Maintenance. The cooling system should either be equipped with a “blank” coolant filter, or the coolant filter and piping may be omitted from the system.
If a non-DDC OAT antifreeze is used, it must conform to TMC 338 specification. Do not add extender to new OAT antifreeze or coolant. Water Only + SCA or Water Only + OAT Inhibitor In warm climates a coolant based on water with corrosion inhibitors is approved for use. Water-only systems need to be treated with the proper dosage of corrosion inhibitors. Detroit Diesel-approved SCAs or OAT corrosion inhibitors must be added to the water to provide required corrosion and cavitation erosion protection. OAT inhibitors such as Power Cool Plus 6000 are available for water-only systems. Inhibitor should be mixed at 7.5% – 10% by volume with water.
For a list of Power Cool products, refer to section Power Cool Engine Products in this guide. Traditional SCA ( Power Cool 3000) can also be used to protect the engine. Power Cool 3000 concentration limits are listed in Table 26. OAT fully formulated antifreezes are available as concentrated and pre-mixed. Concentrated antifreezes should be mixed 50% (50% antifreeze, 50% water). OAT coolants should not be mixed with conventional coolants. If they are mixed, no damage will result, but the long-life advantages of the OAT coolant will be lost. In this event, the coolant should be maintained as a fully formulated IEG coolant, not as an OAT (Organic Acid Technology) coolant. NOTE:
Do not use Power Trac 3–Way Test Strips to test OAT coolant. Detroit Diesel markets a OAT- inhibited ethylene glycol coolant, DDC Power Cool Plus, which contains all the required additives. All information subject to change without notice. (Rev. May 2004) 93 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION