John Deere 450CLC Excavator — Loading Machine On a Trailer

Operation—Operating the Machine 3. Raise side frame 15 degrees off the ground. 4. The side frame must slide against the inside stopper. 5. If side frame does not slide in this condition, vibrate side frame by slowly moving the track back and forth. 6. Lower machine to the ground. T6912AX —19—07APR89 DW90712,000017C -19-29JUN06-2/3 7. Fasten six cap screws (A) as shown (three cap screws at each of the two track frame supports). Tighten to 1720 N·m (1270 lb-ft). Specification Cap Screw—Torque.............................................. 1720 N·m (1,270 lb-ft) 8. Repeat steps 1—7 to move opposite side frame into transport position.

T6912AU —UN—07APR89 A—Cap Screw DW90712,000017C -19-29JUN06-3/3 2-2-21 060313 PN=61