John Deere 450CLC Excavator — Check Windshield Washer Fluid Level

Maintenance—As Required 5. Measure distance (1) at middle track roller from bottom of track frame to top surface of track shoe. Specification Track—Sag...............................................390—440 mm (15.3—17.3 in.) 1— Distance T137528 —UN—24JAN01 TX14740,0001CD9 -19-29JUN06-2/3 IMPORTANT: Prevent possible damage to track components. DO NOT use the grease fitting on the track adjusting cylinder for lubrication. Use this fitting ONLY for track adjustment. 1. To tighten track, connect a grease gun to grease fitting (1) (located through access hole (4) in track frame. Add grease until sag is within recommended limits. T135187 —UN—06NOV00 CAUTION:

Prevent possible injury from high pressure grease. DO NOT remove grease fitting (1) from nut (2). 2. To loosen, slowly turn nut (2) counterclockwise; grease will escape through the bleed hole (3). 3. When amount of track sag is satisfactory, turn nut clockwise to tighten. Specification Nut—Torque............................................................... 147 N·m (108 lb-ft) T135188 —UN—06NOV00 1— Grease Fitting 2— Nut 3— Bleed Hole 4— Access Hole TX14740,0001CD9 -19-29JUN06-3/3 3-3-5 060313 PN=83