SECTION 4 OPERATING Page 16 INSTRUMENTS AND CONTROLS 30. STEERING WHEEL HEIGHT ADJUSTMENT KNOB The steering wheel operates the steering valve, which directs hydraulic fluid into the steering cylinders. When the steering wheel is turned clockwise, the steering cylinders articulate the machine so a right turn can be made. When the steering wheel is turned counterclockwise, the machine is articulated so a left turn can be made. The machine continues as long as you turn the steering wheel. When you stop turning the steering wheel, the machine will remain in the articulated position it is in.
In the upgraded machine steering column height and its inclination can be adjusted (total adjustment ranges up to 80 [mm] and 40 [ ° ] respectively). Adjustment can be made after releasing lever (1, Fig. 4.6). Pull the lever up to extend the steering column. Push it down to change the inclination. Fig. 4.6. Steering Column Adjustment (Upgraded Machine) 1. Lever 31. HORN BUTTON Depress the button to sound the horn, release the button to stop. 32. BRAKE PEDAL This pedal actuates the machine service brakes. Depress the pedal, gradually increasing pressure until a desired braking action is achieved. The faster pressure is applied to the pedal, the stronger is the braking action. 33.
BRAKE AND TRANSMISSION DISCONNECT PEDAL This pedal works in the same manner as the brake pedal except that it also relieves clutch pressure in the transmission. When this pedal is depressed, no power can be transmitted through the transmission and full engine power can be used to operate the machine hydraulics while braking. WARNING! Do not press the transmission disconnect pedal when traveling fast or going downhill because this shifts the transmission into neutral. Loss of control or damage to the power train could result when the pedal is released and transmission re-engages. OM515C520C99/1E DRESSTA