Komatsu — 4.17.3. BUCKET CONTROL LEVER POSITIONS

OPERATING SECTION 4 Page 37 LOADER OPERATIONS 4.17.3. BUCKET CONTROL LEVER POSITIONS (Fig. 4.31) Fig. 4.31. Bucket Control Lever Positions (Standard Version) E. Rollback B. Hold C. Dump The bucket control lever is situated on the RH side of the operator’s seat and close to the boom control lever (closest to the operator's seat). It has three positions E, B, F ("roll back, "hold", and "dump"). Refer to Par. 4.17.1 (Fig. 4.29) for the location and positions of the bucket and boom control lever (upgraded version). It can take 3 positions: F - dump, B - hold, E - rollback. IMPORTANT:

Holding the control lever in any position except B "hold" and D “float" for an extended period of time after the hydraulic cylinder rod has reached the limit of its travel will produce excessive heat in the hydraulic system which may affect loader performance. ROLL BACK E (Fig. 4.29 and 4.31) To roll the bucket back (load the bucket) pull the lever: a) in standard version: all the way back, b) in upgraded version: to the left towards the operator. When the automatic leveler is inoperative, the lever automatically returns to the hold position when released. When the automatic leveler is operative, the lever will be locked automatically with the solenoid latch.

This latch can be released manually. HOLD B The control lever, if not in E detented position, will return automatically to hold position B when released and will maintain the bucket in the required position. DUMP F To dump the bucket, push the lever: a) in standard version: all the way forward, b) in upgraded version; to the right, away from the operator. When the lever is released, it will automatically return to hold position B. DRESSTA OM515C520C99/1E