John Deere Omar287594 — Attaching PTO-Driven Implement

Drawbar and PTO Installing and Using Clevis Assembly IMPORTANT: Remove clevis assembly, before using PTO shaft, or whenever PTO shaft might cause interference. Clevis assembly (A) must be attached ONLY to top of drawbar. RW26279 —UN—12JUN99 Install clevis assembly and tighten cap screws (B). Clevis Assembly Retaining Cap Screws—Specification Category 3—Torque ........................................................ 610 (450 lb­ft) Category 4—Torque ........................................................ 430 (318 lb­ft) A—Clevis Assembly B—Cap Screw RX15494,000007D ­19­18SEP07­1/2 Clevis assembly (A) must be attached ONLY to top of drawbar. Remove lock pin (B).

Lift pin with handle (C) and position in notch of clevis assembly. Attach implement. Insert pin only through drawbar, not through clevis assembly, if towed implement also has a clevis assembly. DO NOT insert pin through all four members. RW26280 —UN—12JUN99 A—Clevis Assembly B—Lock Pin C—Pin with Handle RW26281 —UN—12JUN99 RW26282 —UN—12JUN99 RX15494,000007D ­19­18SEP07­2/2 70­4 122208 PN=170