1500 Hour Service NOTE: Do not remove inner snap ring. Grease may push ball joint from guide resulting in disassembling and reassembling components. H 6. Compress snap ring enough to rotate in slot until it aligns with grease fitting hole. 7. Remove plug from hole (H) and install grease fitting (A). RXA0093500 —UN—23APR07 A IMPORTANT: Too much grease may damage Oring (B). NOTE: Use John Deere SD Polyurea grease or other grease as specified in Fuel, Lubricants and Coolant section. Grease Fitting B 8. Grease inner ball joint until grease (C) is visible around ball joint. 9. Remove grease fitting, install original Allen head plug and tighten to torque.
C RXA0085959 —UN—18JAN06 Specification Allen Head Plug—Torque ................................................ 0.904 (8 lbin) 10. Install snap ring retainer. 11. Install outer snap ring. 12. Slide boot (G) back into steering rod (F). 13. Replace boot retaining snap ring (D). Install Grease Fitting IMPORTANT: If tie band is not pulled tight, dirt and other foreign material will damage components. 14. Attach tie band (E) to boot, then pull tight. A—Grease fitting B—Oring C—Grease D—Boot Retaining Snap Ring E—Tie Band F—Steering Rod G—Boot H—Hole RXA0085960 —UN—18JAN06 Replace Boot OURX935,00002DE 1919JUN082/2 1068 122208 PN=288