General Services Removing and Installing Fan Belt 1. Raise hood. 2. Remove four cap screws (B) and righthand front side panel (A). A 3. Remove three cap screws (C) and lift diverter panel (D) out. RXA0085938 —UN—18JAN06 4. Loosen jam nut (E) on bleed screw (F). B IMPORTANT: Removing bleed screw will drain oil. Loosen bleed screw only enough to bleed oil back into reservoir (a maximum of two full turns). Remove Front Side Panel 5. Loosen bleed screw. IMPORTANT: When prying rear pulley rearward, make sure that belt contact surfaces of pulley are not damaged . D C RXA0085939 —UN—18JAN06 6. Insert flat tipped tool between drive pulleys and carefully push rear pulley (G) rearward until it stops.
NOTE: Bleed screw must be closed for proper tension to be applied to belt once tractor is started. C 7. Close bleed screw, tighten to specification and tighten jam nut. Diverter Panel Specification Bleed Screw—Torque...................................................... 25 221 lbin. G I J A—Side Panel B—Cap Screws C—Cap Screws D—Diverter Panel E—Jam Nut F—Bleed Screw G—Rear Pulley H—Wrench Front Pulley J— Cap Screw F RXA0085940 —UN—18JAN06 E H Continued on next page OURX935,000050F 1916SEP081/3 Bleeding Drive Assembly 1106 122208 PN=303