Komatsu — HANDLING THE TIRES

HANDLING THE TIRES HANDLING THE TIRES PRECAUTIONS WHEN PRECAUTIONS WHEN DRIVING HANDLING TIRES MACHINE If the following defects are found in tires, for safety reasons the tire should be replaced with a new tire. When the machine travels at high speed for a long distance, the tires become extremely hot. This causes early wear of the tires, so it should be avoided as far as possible. If the machine must be driven for a long distance, take the following precautions. The following is a guide to suita- ble tire pressures and speeds when traveling on a paved sur- face with standard tires. Tire pressure: Front 4.0 kg/cm2 Rear 4.0 kg/cm2 Speed:

13 km/h Check the tire pressure before starting, when the tire is cool. After traveling for 1 hour, stop for 30 minutes. Check the tires and other parts for damage; also check the oil and coolant levels. Always travel with the bucket empty. Never put calcium chloride or dry ballast in the tires when traveling. Bead wire is broken or bent, or the tire is greatly deformed. Wear is excessive and the car- cass ply (excluding breaker) is ex- posed for more than l/4 of the circumference. Damage to the carcass exceeds 1 I3 of the tire width. Tire layers are separated. Radial cracks reach the carcass. Deformation or damage which makes the tire unsuitable for use.

l Follow the regulations related to this machine, and drive carefully. l The most suitable tire pressure, travel speed, or tire type differ ac- cording to the condition of the travel surface. Contact your Komatsu distributor or tire dealer for information. Tread Sidewalls Breakers ‘Beads - 62 - N-01301