Chassis Electrical Control Systems 54.40 General Information 4 3 2 5 1 f310477a 02/24/2006 1. Lock Plunger 2. Return Spring 3. Control Linkage 4. Air Cylinder 5. Slide Rail Fig. 5, Fifth Wheel Slide Assembly switch is in the air line. A grounded feedback circuit from the closed pressure switch indicates that the fifth wheel slide is activated and pressure is being supplied to the fifth wheel slide air cylinder. An open feedback circuit indicates that the fifth wheel slide is not activated, or there is a malfunction; the fifth wheel slide is turned on but the pressure switch is still open. axle and save wear on the tires and axle. Tag axles are located behind the rear drive axles.
Pusher axles are located in front of the rear drive axles. The con- trol system for operating a tag or pusher axle is com- monly referred to as axle lift. Tag and pusher axles may only be lowered at vehicle speeds slower than 5 mph (8 km/h), but may be raised at any speed. To avoid damage to a tag or pusher axle, most axle lift controls automatically raise the axle when the vehicle is backing up. The tag or pusher axle returns to the lowered position when the vehicle is shifted out of reverse. Tag/Pusher Axle Lift Tag and pusher axles are available on a variety of M2 vehicles. Tag and pusher axles are free-spinning axles that are not part of the vehicle drivetrain.
Using air pressure, these axles are raised or lowered on the vehicle chassis. A vehicle with a reverse caster axle does not auto- matically raise the axle when backing up. These axles have air controls that change the caster angle of the axle to allow the axle to self-steer according to the direction of travel. Shifting the vehicle into re- verse prompts the CHM to signal a caster angle change. With the axle’s caster angle adjusted so that When lowered, tag and pusher axles increase the weight capacity of a vehicle by distributing the ve- hicle load over more wheels.
When increased weight capacity is not needed, the operator can raise the Business Class M2 Workshop Manual, Supplement 22, September 2012 050/5