Cab Heater and Air Conditioner, Valeo 83.00 Troubleshooting The fan switch is on any setting other than off. make sure that the engine speed is available (make sure it registers on the tachometer). The evaporation sensor temperature is above 40.1°F (4.5°C). Backlighting Circuit Tests When these conditions exist, the control head sends the A/C request signal to the bulkhead module. See Fig. 2 . See Table 11 for the backlighting circuit tests. Per- form the tests in Table 11 in the sequence pre- sented. The directions under the column "What to Do if Test Fails" are sometimes dependent on good re- sults from previous tests.
If any of the tests fail, stop and perform the specified repair or check. If all of the NOTE: The A/C signal will remain active until the evaporator sensor reaches 38.3°F (3.5°C), the fan is turned off, or the air selection switch is taken out of defrost or A/C mode. Control Head (climate control panel) Bulkhead Module (BHM) Binary Pressure Switch High Cut Out 427 to 484 psi (2944 to 3337 kPa) High Cut In 313 to 427 psi (2158 to 2944 kPa) Low Cut Out 27 to 35 psi (186 to 241 kPa) Low Cut In 28 to 36 psi (193 to 248 kPa) BHM sends 12V through the binary switch to the A/C clutch when it receives the A/C request from the control head and the following conditions are met:
−Engine has been running more than 5 seconds. −Battery voltage is greater than 9.25V. −Low air pressure status is not active (not low air). −A/C clutch countdown timer conditions have been met.* A/C Relay Control Control panel grounds A/C request to BHM when control rules are met. A/C Clutch 08/01/2006 f543963 * See A/C clutch cycle timer strategy note above. NOTE: Binary pressure switch positions indicate little or no system pressure. Fig. 2, A/C Clutch Control Circuit See Table 10 for the A/C clutch circuit tests. Perform the tests in Table 10 in the sequence presented. The directions under the column "What to Do if Test Fails" are sometimes dependent on good results from previous tests.
If any of the tests fail, stop and perform the specified repair or check. NOTE: If these tests pass and the A/C clutch still will not engage, check the following— tests pass and the backlighting at the control head still does not operate properly, check the control head. Fault Codes If the A/C clutch is not working, use ServiceLink to check for fault codes. See Table 12 and Table 13 for a description of the fault codes. make sure that the air system does not have an active low air pressure warning; make sure that the battery voltage to all BHM inputs is above 9.25V; Business Class M2 Workshop Manual, Supplement 13, March 2008 300/16 A/C Clutch A/C Request +12V HI LO